Flight Controllers

We have many flight controllers listed below and it is hard to say which is the best for you. The more advanced flight controllers require more advanced soldering skills and some time reading the manuals. I will point of some of the highlights of each FC below starting with the basic.

CC3D

This controller is very easy to configure and power. The included cables make it easy to connect to your flight controller. The GUI software is very good and has a setup wizard to walk you through the process. The code is pretty stagnant has the open source project has gone under different leadership.

Naze32

The naze32 is the most popular controller available now. We are on Version 6 of the controller however there are only minor differences from V5. The acro version does not have a barometer or compass for altitude hold or heading hold. We offer this both with pins and without, and I would recommend the pinned version for first time builders. There is little soldering if any required. You can flash these with Cleanflight or Betaflight if you want to try the leading edge software. I would recommend adding a buzzer to your cart. These can be activated via switch on your RC controller to help find it when it crashes! The GUI is very good, but do logical order to setup your ship, however there are many YouTube videos available.

Skyline32

The Skyline32 runs the same software as the Naze32. This comes with different connectors enabling you do build a very stream lined build. These have the same features as the Naze32 just in a different configuration. I would recommend these for beginners and experts alike as you can connect it with the included wire for a fast easy build, or remove the servo leads and connect directly to the ESC's for a very clean build!.

FuryF3

This is the best board we sell. This is a F3 board where all the other boards are F1, meaning a faster processor. These boards can run faster and have more ports available for items like Sbus, blackbox, and OSD information. When connected to a SBUS receiver the response time is incredible faster and noticeable. This board comes with a SD card slot for logging. This is helpful when troubleshooting and tuning. These do require soldering and not a beginner board. For any advanced builder or skilled pilot this is the ONLY way to go!

Items 1 to 15 of 19 total

Set Descending Direction
per page

Grid  List 

Page:
  1. 1
  2. 2

Items 1 to 15 of 19 total

Set Descending Direction
per page

Grid  List 

Page:
  1. 1
  2. 2